Martin Yale 959 Instrukcje Operacyjne

Model 959AF Air-Feed AutoFolderInstallation, Maintenance, & Operating InstructionsSerial # Table of Contents1.0 Ge

per-inch perforating wheel, and two rubber guide rollers on theupper accessory shaft. On the lower shaft are two backup hubs,and two steel guide rolle

ate instructions in Section 4.2 for the job to be processed. 1. Turn the air and vacuum control valves to the off position.(For refolding, also turn o

To correctly set the spring tension, loosen the screw in the setcollar. Pull the collar away from the spring until there is nopressure on the block. P

5.3.2 Paper Guide AlignmentThe folder is now in a neutral position and ready to be adjustedso sheets of paper enter correctly into the folding rollers

table, no cross shaft adjustment is necessary. If the paperdoes not lay flat on the feed table (climbs up the right or leftpaper guide), adjust the fe

5.6.2 The Vacuum And Air SystemThe pump motor, vacuum, and compressor pumps do notrequire lubrication. 6.0 TroubleshootingThe following guide will hel

instructions in Sections 3.10 and 5.2.2. The air and vacuum set-tings may be set incorrectly. Check the settings according toinstructions in Sections

17PARTS LISTItem # Part No. Qty. Description1 M-O095015 1 Paper Guide Shaft2 W-O095238 1 R.H. Rod Clamp3 W-O095214 1 L.H. Rod Clamp4 W-O095215 2 Grip

18Parts Diagram #1

19

1.0 GeneralOperational setup of the folder is simple and quick. No compli-cated procedures are involved. A simplified fold chart is promi-nently displ

Item # Part No. Qty. Description119 W-O003064 1 Conveyor Idler Shaft120 M-O008011 1 Stacking Wheel Axle121 W-A095064 1 Stacking Tray122 M-S024002 4 Co

To place the foldtables onto themachine, slide thefront slot opening ofthe fold table ontothe inner set of pins(closest to the fold-ing rollers) with

NOTE: When aligning the sheet detector to the targetmarks, look straight down on the target marks andthe edge of the paper. Do not look from an angle

and strikes the fold table paper stop. The sheet then entersbetween the second and third folding roller where the first foldis made. The sheet then en

The position of the foldtable paper stop deter-mines the location of eachfold in the paper. The sim-plified fold chart (Item64A) located on the exitta

4.2.6 The Simplified Fold ChartThe simplified fold chart located on the exit table providespaper stop settings for five standard cut paper sizes. Two

made with the micro adjustment wheels. This is thesame for all fold styles. See Fig. 10When the feedtable paperguides are cor-rectly set and aconsis

For step 2, follow this procedure.1. Remove the first fold table and the stacking wheel assembly.2. Disengage the scoring wheel backup hub by rotating