Martin Yale 1217a Instrukcje Operacyjne Pobierz pdf (Strona 10)

(10)

Static Buildup Check the electrical ground. The Conveyor Table is

equipped with an anti-static brush. To work correctly,

the machine must be properly grounded through the

power cord.

5.4 Crooked Folds

Possible Cause Solution

Excessive side play between Paper Guides. Readjust the Paper Guides and paper edges.

Fold Table Paper Stops improperly set or not locked. Readjust the Paper Stops and lock into position.

Paper not square. Recut paper until square or adjust Fold Table Paper

Stops.

Contaminated Folding Rollers Clean according to instructions in 4.2, Folding Rollers

5.5 Ink smudges on paper

Possible Cause Solution

Ink not dry. Allow additional ink drying time before folding. Some

inks do not dry, they only set (dry to the touch).

Because of the physical nature of friction feeding, you

may notice a mark on the leading edge of the paper.

Excessive toner on photocopied stock. Check copy machine.

5.6 Paper Jams

Possible Cause Solution

More than a single sheet feeding into the folder. Readjust the Retarder Assembly according to the

instructions in Section 3.2. Replace the Feed Wheel

Assembly or rotate Retarder Assembly if necessary.

Folded sheets backing into the folder. Reset the Stacking Wheels according to instructions in

Section 3.4, Stacking Wheels.

Paper Jammed in Rollers To remove paper jams manually, make sure the folder

is unplugged. Insert a large (3/8”) flat tipped screw-

driver into the slot located in the shaft, just inside the

small access hole on the Right Side Cover. Turn the

screwdriver clockwise to rotate rollers in a forward

direction. It may be necessary to remove the 1st Fold

Table top by removing the two thumbscrews and slid-

ing it off the rubber grommets.

1 2 ... 5 6 7 8 9 10 11 12

Brak uwag

Martin Yale 1217a Instrukcje Operacyjne Strona 10